Re: wiring harness part# and specs to go from dash board to the tilt/trim pump (merc

[Keadyshockers]

Re: wiring harness part# and specs to go from dash board to the tilt/trim pump (merc

Hi, In reference to this old thread: http://forums.iboats.com/boat-topic...dash-board-tilt-trim-pump-mercury-560521.html

Is there a manual anywhere for this unit, I have the 45060A1 with one solenoid and the three button switch ? I understand you can set trim with one of the buttons, but have never used one of these and am putting the motor on a Grew ss140.

 

[achris]

Re: wiring harness part# and specs to go from dash board to the tilt/trim pump (merc

Re: wiring harness part# and specs to go from dash board to the tilt/trim pump (merc

The way the system works is that the bottom button trims DOWN (all the way from top to bottom)... The centre button operates trim UP (from full down to about 1/3 up). To get the engine to tilt all the way up, you need to press both centre and top buttons simultaneously.

If the centre button does nothing with the engine at full DOWN, then the trim limit switch is faulty...

No manual, but I do have a circuit diagram if you would like it...

Chris.......

 

[Keadyshockers]

Re: wiring harness part# and specs to go from dash board to the tilt/trim pump (merc

Re: wiring harness part# and specs to go from dash board to the tilt/trim pump (merc

Thay would be great Chris, just trying to get this unit working. Makes noise in one direction ?

 

[achris]

Re: wiring harness part# and specs to go from dash board to the tilt/trim pump (merc

Re: wiring harness part# and specs to go from dash board to the tilt/trim pump (merc