PTT Motor Shims

[Justinde]

Hi all

Another follow up to some of my previous posts.

Anyone looking for the shim that sits above the 'drive shaft' of the PTT motor, I used an old bread board. Cut it down, used an angle grinder to shape it, and it works a charm.

This ultra hard plastic is uv resistant, heat resistant and wear resistant, and no, I don't sell bread boards!!

Just thought I'd post this in case anyone else is looking for a solution for these very hard to find shims.

Cheers from Down under ;-)

 

[MickLovin]

Re: PTT Motor Shims

Don't have a spare tilt trim motor do you

 

[Justinde]

Re: PTT Motor Shims

No, but a spare bread board I do have......

 

[Justinde]

Re: PTT Motor Shims

No, but a spare bread board I do have......

 

[MickLovin]

Re: PTT Motor Shims

I don't need to fillet fish buddy just raise my motor

 

[Justinde]

Re: PTT Motor Shims

Use the new Armstrong PTT pump........Worked well before hydraulics;-)