Plugs are fouling

Cally16

Recruit
Thread starter
Joined
Jul 14, 2003
Messages
1
I was wanting to know if anyone could help me figure out how to remedy a problem I may have created. I have a 92 Johnson 120 V4 :confused: that I have recently disconnected the oil injection to . Now, my plugs are continually fouling out and I am using an amazing amount of fuel.I am using a 50:1 ratio mix in the tank.Is there something else I need to do with the disconnection or do I need to change mixture?<br /><br /> <br />Please Help<br />Thank You, <br />Cally16
 

ob

Admiral
Joined
Aug 16, 2002
Messages
6,992
Re: Plugs are fouling

What plugs are you using?Engine calls for Champion QL77JC4 gapped at .030" or the alternate QL16V surface gap plug usually recommended for sustained high speed operation.<br /><br />What is your fuel consumption?
 

seahorse5

Rear Admiral
Joined
Jan 24, 2002
Messages
4,698
Re: Plugs are fouling

Back in '95 Evinrude and Johnson changed to an extended nose plug for better drivabiltiy. Use the Champion QL78YC gapped at .030" or use the QL82YC for extended trolling or low speed operation.<br /><br />Make sure the thermostats are making the motor warm up to 140 degrees on each cylinderhead and that you are accurately mixing the fuel and oil and not guessing on the rich side.
 

ob

Admiral
Joined
Aug 16, 2002
Messages
6,992
Re: Plugs are fouling

Not to question seahorses' recommendation on use of the QL78YC plug,which I use in my 96' Evinrude,however the OMC plug chart that I used shows 93' as the first year that the QL78YC plug is listed for the Johnson 120 hp.However in support of his recommendation I would only say that if there is no mechanical interference with the QL78YC then there is definately no harm in trying them.
 
Top