OMC Orifice Driver prt. no 317002

[ncornett]

I'm going to rebuild my carbs on my j60tletd. i have the shop manual. it calls for using this orifice driver to remove the high-speed orifice. I don't have one of these and was wondering if i could use something instead (small screwdriver, etc.)?

I'll probably have many other questions and appreciate the help.

Thanks in advance.

 

[rickdb1boat]

Re: OMC Orifice Driver prt. no 317002

I used a screwdriver that was wider than I needed and filed it down with my grinder(Diameter) until it just fit through the hole. This gave me a nice wide blade that fit in the jet slot tightly for a sure grip..Don't want to bugger the jet up...

 

[ncornett]

Re: OMC Orifice Driver prt. no 317002

thank you.