Need Johnson Flywheel

[whitey74]

Just wondering if anyone knows of a good place to get a flywheel for a 1988 Johnson 200hpV6. Just popped it off and found all the magnets loose. Was looking into a repair kit also, but then I would still need to have it rebalanced, and it would take a lot of elbow grease to clean it up.

 

[elisa191]

Re: Need Johnson Flywheel

yes... pressison manufacturing in fl. # is 18004232202 very good very cheap.

 

[whitey74]

Re: Need Johnson Flywheel

No luck for my model, but thanks for the response.

 

[clanton]

Re: Need Johnson Flywheel

You glue the magnets back to the flywheel with DURO epoxy after you clean all old epoxy and rust from the flywheel. If it is a 35 amp flywheel the magnet spacing is close to 7/16s. The small notch on the magnet faces up when the flywheel is upside down and you are installing the magnets. It will work fine on standard engine without rebalance.

 

[whitey74]

Re: Need Johnson Flywheel

Thanks Clanton. After a little research a new one would be over $500. To have it reglued $200. Besides the money, I tend to trust my work more than others. Time to start cleaning.