Need help with a late 80s 115hp Evinrude

TBond

Cadet
Thread starter
Joined
Jan 1, 2016
Messages
6
I am a new boat owner and don't know much about boat motors. I have a late 80s 115hp Evinrude that ran good when I first bought the boat. The boat starts fine when first put it in the water but when I drive it for a little while then turn it off I have a hard time getting it to restart. It turns over like it wants to start but it just won't even if I choke it and pump the primer bulb up. I had a tune up done back in June and they said it had good compression and they changed the plugs but that didn't help the issue. Any help would be greatly appreciated
 

TBond

Cadet
Thread starter
Joined
Jan 1, 2016
Messages
6
Yes I've tried using that and not using it and it doesn't seem to make any difference
 

flyingscott

Fleet Admiral
Joined
Apr 8, 2014
Messages
8,348
When it happens check for spark will need a spark tester available at any auto parts store needs to jump 7/16"
 

emdsapmgr

Supreme Mariner
Joined
Dec 9, 2005
Messages
11,551
Agree, check spark. Weak ignition components tend to fail, once they heat up to normal operating temps. 143 to 150 degrees. If you've run the engine for a while, then shut it off, the engine heats up more (normal with no water circulating thru the block) and the ignition components can get heat-soaked and not work. Maybe 160 degrees or slightly higher (this is normal after a shutdown.) If you wait a long period till the engine cools of (maybe overnight) the engine may run just fine the next day, only to fail once it heats back up to normal temps.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Take the starter apart and inspect it.---Slow cranking can mean a hard to start condition.
 

tommarvin

Ensign
Joined
Nov 22, 2015
Messages
999
Its spark or fuel, when old coils start going out, and get hot they do this sometimes, weak spark replace weak coil, check spark plug wire.
Are the carbs clean,and the jets clean.
 

emdsapmgr

Supreme Mariner
Joined
Dec 9, 2005
Messages
11,551
Does this late 80's V4 have one or two power packs? OMC went to single power packs for this engine in 1988 on the 110 models.
 

emdsapmgr

Supreme Mariner
Joined
Dec 9, 2005
Messages
11,551
That's good. The 86 has dual identical power packs. Each controls the spark to one head (2 cylinders.) If you can determine which plug is not firing, on one head, you can do your own troubleshooting. Swap the power packs. If the "no spark" condition moves to the other head with the power pack move, it's likely that one pack is bad. Replace it. If the swap makes no difference and you still have weak/no spark on one plugwire, it could be the stator or the timer base. You can troubleshoot both of these if it comes to that.
 

TBond

Cadet
Thread starter
Joined
Jan 1, 2016
Messages
6
Thank you for your help hopefully I will be able to fix it with everything you've told me
 
Top