Hey guys, I bought a screw on 10 micron fuel filter to add to my '97 Sea Pro 190WA powered by a Mercruiser I/O. It seems like I can just drill the bolt pattern into the bulkhead separating the engine compartment from the area immediately fore of that, that actually houses the gas tank, the bilge, etc.
I bought some stainless steel lag bolts of appropriate size but wanted to double check that this is the best way to do this. I plan on just drilling the holes out and then using those lags to hold the fuel filter subassembly to this bulkhead.
Thanks in advance for any comments!
Best,
Trev
I bought some stainless steel lag bolts of appropriate size but wanted to double check that this is the best way to do this. I plan on just drilling the holes out and then using those lags to hold the fuel filter subassembly to this bulkhead.
Thanks in advance for any comments!
Best,
Trev