Hey I have an Mariner 3.3 hp outboard, I just did some wimple service on it:<br /><br />Replaced the spark plug<br />Lubricated the points it says to lube in manual<br />Cleaned the fuel level thing that has the little float<br />Replaced gearbox lubricant<br /><br />Okay, now the motor starts fine and I can rev it in idle all the way with no problems, but when I put her into gear I can not rev it it will just start stalling and will eventually cut out unless I drop the revs right off. Does anyone know what may cause this?<br /><br />I'm testing it out in a rubish bin with fresh water, i'll take it down to the river and try tommorow morning but I do not know if that will make a difference.<br /><br />P.S. I have tried the choke