Johnson lower unit "wanted"

[BB79RANCH]

I am in need of a good used or rebuilt lower unit for my '81 Johnson 50 h.p. outboard.<br /> <br /> Todd<br /> BB79RANCH

 

[pinkmouse]

Re: Johnson lower unit "wanted"

do you have the lenght .i will check in the morning

 

[BB79RANCH]

Re: Johnson lower unit "wanted"

I will be able to give length tomorrow afternoon, is that too late? Where would you like measurements tken from, case to top of driveshaft? Please E-mail back, I'm new to this outboard stuff, but I already know how expensive it is. Thanks for the quick reply and I'll get back to you ASAP.<br /><br /> Todd<br /> BB9RANCH

 

[BB79RANCH]

Re: Johnson lower unit "wanted"

I will be able to give length tomorrow afternoon, is that too late? Where would you like measurements taken from, case to top of driveshaft? Please E-mail back, I'm new to this outboard stuff, but I already know how expensive it is. Thanks for the quick reply and I'll get back to you ASAP.<br /><br /> Todd<br /> BB79RANCH

 

[pinkmouse]

Re: Johnson lower unit "wanted"

do tou have the model numbers off the motor.if not just measure the shaft from the pump base to the tip of the staft.or lower on motor,from the top of the transom bracket to thecavitation plate,this is thearea that sticks out just above the prop

 

[BB79RANCH]

Re: Johnson lower unit "wanted"

The model number is J50BELCIC, the measurement from water pump base to tip of input shaft is roughly 21 1/2 inches.<br /> Todd<br /> BB79RANCH