Johnson 110 v4 - will start but won’t run

Fastrack010

Recruit
Thread starter
Joined
Aug 14, 2018
Messages
3
Has been in shed for 3 or 4 years. Ran when put away. It will start now, but won’t run. Doesn’t appear to be any air leak. Plugs were new when put away and look good. What else should we try?
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Were carburetors drained when motor was put away , yes or no ?-----Likely it is running on fuel supplied with the electric primer.----That fuel bypasses the carburetors.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
This may mean that the high speed jets in the bottom of the bowl are plugged.--------Only way to find out is to pull them apart for cleaning.-----The high speed jets are screwed into the float bowl way inside after removing the drain plugs.----@ of them per carburetor.----Not hard to do this job yourself.
 

reelbrothers

Cadet
Joined
Aug 20, 2016
Messages
14
you can unscrew the Jets and push a toothpick in it to extract out hole. I wonder if diaphram in fuel pump is shot, may not be pulling fuel, your only getting what bulb pushes In? and here's one of those boats drive me crazy things, one of my ign swith went bad, when key was in crank position it was ok, in run position no voltage on tab....
 
Top