I need help in Identifying my Sears

[wolfse]

I have a two bladed Sears outboard. There is a small metal plate under the front of the outboard and above the transom clamps. It has the following numbers:

6092

09511 B

Can anyone help me identify what yaer she is? Thanks in advance for your help!

 

[steelespike]

Re: I need help in Identifying my Sears

6092 is a 66 Clinton built 3.5 hp.It uses a Clinton aircooled power head with a water cooled exhaust leg.Clinton has been out of business since about 81.

 

[wolfse]

Re: I need help in Identifying my Sears

Thanks for your response. I had no idea what I was dealing with. It starts up and runs for about 5-10 seconds then stops. After it stops it takes a few minutes before it starts again and it only runs for about 5-10 seconds or so. I have replaced the 2 fuel lines but I'm figuring that the carb./float is the problem.

 

[frwhlr38]

Re: I need help in Identifying my Sears

Sounds to me like the carb needs to be cleaned and redone, i would imagine it has some gum in the small little passigeways of the high low speed airways

 

[steelespike]

Re: I need help in Identifying my Sears

Sometimes there is a filter inside the tank. Usaually if you remove the fitting the filter comes with it.Probably could just check the flow first.