With our old BF225 the procedure was to pull the safety clip, put in gear, turn key to run position then push the safety lanyard button 5 times.
The process doesn’t work on the new 250 we just installed. This motor uses the fly-by-wire controls and new style ignition module.
Does anyone know how to reset the maintenance reminders? I have engine maintenance alarms turned off on the digital display but would like to use them if I can figure out the reset procedure.
The process doesn’t work on the new 250 we just installed. This motor uses the fly-by-wire controls and new style ignition module.
Does anyone know how to reset the maintenance reminders? I have engine maintenance alarms turned off on the digital display but would like to use them if I can figure out the reset procedure.