Hey Don, what do you think of this?

[f_inscreenname]

I still need to clean it up a little but this is how it works.

Grease in where it says "in" and where it comes out is just short of the inner part of the bearing. Or even with the lip inside the bellhousing that the bearing rests against. The bearings sit inside their case almost a 1/4" so there is enough room so that they never can hit the tip (unless something really bad happens) and for grease to squeeze out a little.
I am thinking this may work. What do you think?

 

[Don S]

Re: Hey Don, what do you think of this?

Looks good to me, One suggestion I would make is to run the engine at idle when greasing the bearing. Might help work the grease thru the bearing

 

[f_inscreenname]

Re: Hey Don, what do you think of this?

I was thinking the same thing and with the pressure it comes out at, blowing the bearing out of the bellhousing also. (LOL)

With just a little pressure on the grease gun handle and very little handle movement it squirted grease half way up the bellhousing.8)