Help! 1966 Evinrude Big twin 40HP no spark

Npr9155

Recruit
Thread starter
Joined
Jun 22, 2016
Messages
4
I recently acquired a 1966 Envinrude Big Twin 40HP that was sitting in a barn since 87'. Wasn't getting any spark. So far replaced both coils, condensers, spark plugs, and points. Still no spark. Points and coil gap set according to spec. Only thing left I can think of would be to replace the cables themselves. Any suggestions would be greatly appreciated, first time working on a boat motor and learning as I go.
 

jimmbo

Supreme Mariner
Joined
May 24, 2004
Messages
14,699
Welcome to iboats
Is it an electric start or a rope start? I ask because if it has a ignition switch there could be an issue in that switch or wiring.
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
Disconnect the two thin black wires coming out of the magneto (one goes to the cut-out switch) See if you have spark with those two wires disconnected. No spark?? Go back in and double check your work. And clean those points. Even new ones need cleaning. They have an invisible, non-conducting "stuff" on the contacts.
 

Npr9155

Recruit
Thread starter
Joined
Jun 22, 2016
Messages
4
Thanks for the quick responses. It is an electric start but also has a rope start. Also just put in a new ignition switch yesterday, to no avail. F_R as far a the as the black wires, are you talking the one that comes out of each coil under the flywheel? Could it also possibly be that my wiring to the ignition was not 100%
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
Yes, those are the wires. There are two spark wires and two kill wires coming out the bottom of the mag plate. I told you to disconnect the two small ones (kill wires) to eliminate any possibility of the trouble being elsewhere (yes including the ignition switch)
 
Top