Have No Forward or reverse

kirmy22

Seaman
Joined
Mar 8, 2010
Messages
73
Sorry if this horse has been beat to death. I have a 1981 mercury 150 serial no. 6424308 just replaced the waterpump and thermostats, put it back together pumps water fine but no forward or reverse did the repair on the pump with the boat in neutral. I have a Seloc manuel just about as worthless as tits on a snake, did I completly miss the alighnment on the shifter or did I mess something else up. Thanks in advance for the help, this is a great forum.
 

gm280

Supreme Mariner
Joined
Jun 26, 2011
Messages
14,605
Re: Have No Forward or reverse

Well for starters, did you reconnect the shift rod back up...correctly...? You had to disconnect it to pull the LU to replace the impellor... Did you remove any other bolts on the lower foot section?
 

kirmy22

Seaman
Joined
Mar 8, 2010
Messages
73
Re: Have No Forward or reverse

Didnt have to disconnect it, its a splined shaft just slides in
 

carholme

Rear Admiral
Joined
Sep 4, 2010
Messages
4,845
Re: Have No Forward or reverse

That s/n comes up as:

MERCURY - (150 H.P. (1983 ))
Serial No: 06424308 Model No: 1150623

Parts List for model 1150623:

150 H.P. XR-2 MARATHON MAGNUM (V-6) (1978-1985 COMBINED BOOK) - Mercury, Mercruiser, Force, etc. Parts Lookup

Service Manual P/N: 90-976583

Mariner Outboards, Mercury Outboards, Service Manual, Models V - 135 Thru V - 225 with Serial Numbers 5464486 and Up #90-90-976583, 1988: Mercury Marine Soft Cover, First American Edition - All Booked Up

In the interim, here is a link to the condensed version of the Clymer manual to help you with the LU installation. Download it soonest to your computer as the link is short lived.

Small Engine Repair Reference Center Home: MERCURY - MERCURY V-6 (EXCEPT 300 AND 3.4L).

See page 336:

Do not apply excessive grease to drive
shaft splines; there must not be grease
on tops of drive shaft or shift shaft. Shift
lower unit to forward gear and move
guide block anchor pin on engine to forward
gear position.

Gerry
 
Top