GT-150 electronics troubleshooting

[qcernie]

1990 V6 crossfire. Intermittent no spark. Did all of the checks in the CDI troubleshooting section. Everything was in spec except brown to brown yellow wires. I get 235 volts connected but no voltage disconnected. Can't find this situation in the troubleshooting guide. Any ideas. Stator and pack have both been replaced.

 

[emdsapmgr]

With a "peak reading" voltmeter, connect it to the rubber connector from the stator: the black to the A terminal (brown stator wire) and the red to the B terminal (brown with yellow tracer.) When cranking at 250 rpm's you need to have at least 200 volts. Page 3-46 from the 1990 factory service manual. Yours sounds ok. Ditto between the C and D terminals.