Recently bought 2008 lund rebel and found out the gas gauge is always full and speedometer is not working. Through research found out the gas gauge sender unit could be bad or I have a short in the pink wire. The common problem with speedometer is plugged hole. Did check hole in lower unit and appears to be open but have not disconnected hose to blow air although (next step). Before I start removing the gauge panel to get to gas gauge and floor panel to get to sending unit was wondering if the gauge and speedometer could be a combined problem? If speedometer is purely pressure or is power involved also? Found a lot of useful information on site for gas gauge but only information on speedometer was plugged hole. Any information would be appreciated before I start. Thanks schemmy