Fuse Block problem?

ECUpirate

Recruit
Thread starter
Joined
Aug 6, 2011
Messages
2
I recently installed a new stereo system in my boat an it works great, however since then I have ha problems with the engine not being able to turn over yet I still get electricity to it an the console including my stereo. I tinkered with the fuse block thinking that may be the problem an it actually started afterwards then would go back to not starting. also I'll add that when I turn the key, the two gauges I have for fuel an rpms, the needles spike an the engine won't turn over. I cant figure this out, I found a cut in the battery cable an a small amount of corrosion, but not a substantial amount that would hinder enough power to crank the engine. If anyone has experience something like this or may have an idea please share that that info, thanks.
 

Barnacle_Bill

Admiral
Joined
Feb 8, 2004
Messages
6,469
Re: Fuse Block problem?

What exactly are you working on? Where was the corrosion? Have you checked to make sure all connections are clean and tight?
 

bassman284

Commander
Joined
Jun 24, 2006
Messages
2,840
Re: Fuse Block problem?

This is Mother Nature's way of telling you that boats should not have stereos.
 

ECUpirate

Recruit
Thread starter
Joined
Aug 6, 2011
Messages
2
Re: Fuse Block problem?

There was a small amount of corrosion on the battery cable, there was a slit down the rubber exposing the wire, but not enough to restrict current from getting to the engine. All connections are tight and in the right place, just when I turn the key to start it, I get electricity to the console, but when I turn the key the gauges spike or move whenever I turn it and the engine will not turn over. When I have tampered with the fuse block I have been able to start it, but it eventually goes back to the same problem. I actually just dropped it off at a mechanic so I guess he'll figure it out...
 
Top