Evinrude Lightwin 4hp (1970) problems - stalls and locks

ospreydinghy

Recruit
Thread starter
Joined
Jul 11, 2018
Messages
1
Hey everyone- recently picked up a 1970 Evinrude Lightwin 4hp outboard for a restored dinghy I've been working on. This is my first outboard so please pardon my ignorance...
I cleaned and greased it up and got it starting just fine. Took it out on the water and it seemed to be doing alright. About five minutes in, the motor sputtered to a halt and the cord/flywheel became locked. Rowed to a nearby dock, and with a few light pulls, got the cord free again. Started it back up and took it back out. A few minutes later, the same thing happened, though this time I can't advance the cord.
Any ideas what this might be? Thanks!
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Sounds like the water pump is not working.----And I believe your motor is now ruined.---Did you mix gas and oil at 50:1 in the tank ?-----If it still spins do a compression test.
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
Doesn't sound good. You might drop the lower unit and see if that frees up the powerhead.
 
Top