Evinrude 35 will not run, compression?

theresheblows74

Recruit
Thread starter
Joined
Jun 1, 2017
Messages
4
I just bought my first boat. Its a early 80s pontoon with the Evinrude 35 horsepower motor. Previous owner ran it hot. What should the compression be on this engine? Ive checked it twice and got 100psi in both cylinders. I talked to a mechanic and he said this was too low. Said mechanic was also trying to get me to trade in and buy another motor. So Im asking some advice here. What should the psi be to run? Thanks
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Does it not start at all ?----It will run with 100 psi.-----But may not run very well.-----If it ran hot you need to inspect wires that may have melted and are shorting out ignition bits.------Does spark jump a gap of 3/8" on both leads , yes or no ?
 

ondarvr

Supreme Mariner
Joined
Apr 6, 2005
Messages
11,527
The compression can vary depending on the gauge used, so saying it's low with those numbers could be correct, or it might not be, it can be more important that they are close to each other. You can check the head gasket for leaks, and while you're there see what the cylinder walls look like, this will tell what you want to know.
 

Chinewalker

Fleet Admiral
Joined
Aug 19, 2001
Messages
8,902
There's running hot, and there's the pistons are melted enough to resemble aluminum ingots. Given that you've got fair compression as it is, you're likely not at the melted piston stage, but there's still a good chance you've got stuck rings and/or scuffed piston skirts. Overheating can also take the temper/springyness out of piston rings, which can lower compression, too. As noted above, I'd pull the head and inspect some things inside before going much further.
 

theresheblows74

Recruit
Thread starter
Joined
Jun 1, 2017
Messages
4
Hi thanks for the information. The engine has a nice blue spark per each cylinder. The time I got it running it acted like it was flooded so I have the carburetor off now and limited time to work on it. I am looking at another good engine for the time being until I can tear this one apart. And yeah when I say hot it slightly melted wire loom, coil mounts, plug boots. I took the lower unit off and the water pump looked fine but.. the key way for the impeller was missing and the housing was cracked from age.
 
Top