Evinrude 115hp V4 porpoising

Spalding92

Recruit
Thread starter
Joined
Jun 5, 2017
Messages
1
I am definitely a little new to boating, just recently purchased a 1984 Astroglass with an Evinrude 115hp V4. Once i get up to full speed i start porpoising pretty bad. From what i've read i either need to redistribute weight towards the front or add smart tabs. I am a little leary of the tabs since they require drilling into the fiberglass.. What are some ways to redistribute weight? Almost all of it is in the back of the boat. Motor, bateries, gas tank..
 

CaptnKingfisher

Petty Officer 1st Class
Joined
May 14, 2017
Messages
269
No Title

Trimming your motor down lower should solve the issue
 

Attachments

  • photo266928.gif
    photo266928.gif
    9.2 KB · Views: 0

cfauvel

Chief Petty Officer
Joined
Aug 16, 2005
Messages
645
^^^ as the guy above stated ^^^

plus get a video of the boat running....aimed at the lower unit.....
 

Bosunsmate

Admiral
Joined
Apr 7, 2012
Messages
6,135
This can happen if your outboard anticavitation plate is not lined up with the bottom of the hull.
Some people put sandbags in bow.
I added fins to my motor which stopped it
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
You could have some water weight in there under the floor.
 

jimmbo

Supreme Mariner
Joined
May 24, 2004
Messages
14,699
A few things can cause Porpoising. Too much weight at the stern, too much positive trim for the speed, a hull with a Rocker(picture a rocker from a rocking chair). Are you trimming the engine correctly? Your engine will lower down quite rapidly till it gets to the top of the trim range, then it continues down at a slower rate till it contacts the tilt pin. The Pin should be in the hole closest to the boat. Before accelerating trim the engine all the way down, once the boat is on plane, start trimming the engine up/out. As you reach your desired speed keep trimming until the boat just starts to porpoise, then trim back in just enough to stop the porpoising. If that is not possible, make sure the stern isn't too heavy. If moving ballast forward still hasn't solved it, then an inspection of the hull is in order. Avoid those god-awful fin things that are bolted to the Anti-ventilation plate.
 

jimmbo

Supreme Mariner
Joined
May 24, 2004
Messages
14,699
All my boats have 'popped" on to plane without them. They place a large strain on the tilt tube of the outboard and on the Anti-ventilation plate, and can cause handing and stability issues on some boat and engine configurations. If they really were a good idea, the engine manufacturers would have made the anti-ventilation plates much larger
 
Top