1986 Evinrude 150. I've only had one 40hp Nissan before this and it was recently serviced without any issues... This one I've had to put a bunch of TLC into in order to get it to where I feel safe finally taking it out. Now needing someone with more knowledge to give an ok on it...
Could someone in the know take a gander at this 3 minute long vid to let me know if everything sounds good to go, or if I need to look into anything?
Side note: Is it normal to affect the idle speed when it goes up and down via tilt/trim? It idles a bit faster when engine in in the "up" position.
Could someone in the know take a gander at this 3 minute long vid to let me know if everything sounds good to go, or if I need to look into anything?
Side note: Is it normal to affect the idle speed when it goes up and down via tilt/trim? It idles a bit faster when engine in in the "up" position.
Last edited: