Anyone Recognize This Manufacturer's Stamp?

[johnmsch]

Trying to find a replacement part for my bimini top. Its a 7/8" Stainless Steel Jaw Slide. The company I originally got it from said that they don't recognize the part, and that it did not come from them. The problem is that I ordered all the parts for this top when I bought the top from them 2 years ago. I would not have gone to any other dealer for this part. So now I'm left to try to find out who else might sell this part.

In the two pictures below, notice that the one on the left has a threaded hole, but the one on the right, the hole is a bit bigger and non-threaded. This allows the use of a quick-connect pin. In the second picture, there is a manufacturer's stamp that looks like a crown.

Does anyone know the manufacturer, or where I could get this part?

 

[oldjeep]

This?
http://m.overtons.com/modperl/produ...ide-Stainless-Steel-fits-1-dia-tubing&i=95089

 

[oldjeep]

Ugg - go to O V E R T ON S dot com and search for 34368

 

[johnmsch]

This?
http://m.********.com/modperl/produ...ide-Stainless-Steel-fits-1-dia-tubing&i=95089

That link didn't post correctly. Is something blocking the area with the asterisks?

 

[johnmsch]

This?

http://m.********.com/modperl/produ...ide-Stainless-Steel-fits-1-dia-tubing&i=95089

That link didn't post correctly. Is something blocking the area with the asterisks?

 

[johnmsch]

Ugg - go to O V E R T ON S dot com and search for 34368

Thanks for the link, but that's not the one. I had seen that before, but the slot between the two sides is too narrow.

 

[Bob_VT]

Have you looked at iboats?? http://www.iboats.com/Bimini-Top-Ja...6639786--session_id.179421702--view_id.693691

 

[Watermann]

So why are you trying to replace them anyway, they don't look broken?

 

[johnmsch]

Have you looked at iboats?? http://www.iboats.com/Bimini-Top-Ja...6639786--**********.179421702--view_id.693691

Sure did. The only ones I found had the threaded holes on the end.

 

[johnmsch]

So why are you trying to replace them anyway, they don't look broken?

Notice that the one on the right has a broken screw in the middle hole, and the threads are just about completely stripped. Seems easier to replace it than trying to rethread it using a tap. And as long as I'm replacing that one, wanted to have a spare.

 

[Barramundi NQ]

What about putting a slightly smaller screw with a nylock nut on it? All SS of course.

 

[johnmsch]

What about putting a slightly smaller screw with a nylock nut on it? All SS of course.

That's a great idea. I'm going to attempt to drill it out first. Let's see how long that drill bit lasts.