any gasket remval tricks??

[JStutz]

I am starting my first mercarb (an carb for that matter) rebuild. I was curious if there was a trick for removing old gasket material?<br /><br />Thanks in advance...

 

[RatFish]

Re: any gasket remval tricks??

A sharp single edge razor blade.

 

[ron7000]

Re: any gasket remval tricks??

in addition, a dremel tool with the little wire wheel brush.

 

[DHPMARINE]

Re: any gasket remval tricks??

I use a wood chisel (sharp).But be careful on aluminum.<br />DHP

 

[deputydawg]

Re: any gasket remval tricks??

It is best to use either a putty knife or a gasket scraper. The gasket scraper is a very good tool, but could scratch the aluminum parts. Wire wheel works for those that are really stuck, but be very very careful. I usually use a putty knife or my pocket knife.

 

[rattana]

Re: any gasket remval tricks??

I use a utility knife blade, but you need to make sure that you don't scrape the aluminum. Gasket remover can loosen the hard stuck material but it leaves a bit of a mess to clean up after.

 

[elpaso]

Re: any gasket remval tricks??

Spray gasket remover - at any auto parts store.<br />Spray on let set 10 minutes -

 

[Trent]

Re: any gasket remval tricks??

Roloc bristle discs. They work great.