99 Johnson 25 impeller and shifting problems

Status
Not open for further replies.

Pecenje

Seaman Apprentice
Joined
Jul 1, 2011
Messages
41
Started the motor for the first time this year and no water coming out of the pee hole...

stuck weed eater line through it and it's not blocked (pushed more then 4 feet of it in) also blew it through with air compressor

changed the impeller and housing (complete kit) and re installed and it's still not pumping water????

also i lost forward gear as well so Forward and Neutral are free spinning and only reverse locks up...

any ideas/help would be appreciated

Thanks
 

boobie

Supreme Mariner
Joined
Nov 5, 2009
Messages
20,826
Re: 99 Johnson 25 impeller and shifting problems

If it worked fine before you took it apart, I'd check to see if the water tube is installed and the shift linkage is put together correctly.
 

Pecenje

Seaman Apprentice
Joined
Jul 1, 2011
Messages
41
Re: 99 Johnson 25 impeller and shifting problems

took it all apart again and everything looked right...

put it back together and added more water to the bin i was running it in and it started peeing again...

I would have sworn that i ran it on the muffs last year and it worked fine... I could be wrong though...

the loss of forward gear was the shifter needed being adjusted...

all is well now - World order is restored!!
 

boobie

Supreme Mariner
Joined
Nov 5, 2009
Messages
20,826
Re: 99 Johnson 25 impeller and shifting problems

A little tip. If you run that mtr on muffs, you need a set that puts water on BOTH sides of the pick up. With the one sided ones you can suck air.
 

patodram

Recruit
Joined
Jul 28, 2016
Messages
2
Great info guy!! I have a question how do I adjust the shifter. I replaced a few shifting parts and added a front shift lever. Now when shifting out of forward to neutral it stays in forward. I push the lever a little in reverse it pops in to neutral. And help would be greatly appreciated!!!
 

GA_Boater

Honorary Moderator Emeritus
Joined
May 24, 2011
Messages
49,038
Great info guy!! I have a question how do I adjust the shifter. I replaced a few shifting parts and added a front shift lever. Now when shifting out of forward to neutral it stays in forward. I push the lever a little in reverse it pops in to neutral. And help would be greatly appreciated!!!

patodram

Please start new threads with your questions instead of hijacking old, inactive threads. Read the Help Tip on top of the page. Thanks.

Closed.
 
Status
Not open for further replies.
Top