Greetings all,
93 model j200STLETF SER # g03504324
I am rebuilding my carbs after motor has been sitting. high speed needle is pretty gummed up... so I'm doing a complete tear down and clean.
Here is my question
Boat ran well when I last ran it but the idle was a little rough (a boat shop rebuilt the carbs last)
Anyway each carb (6 of them) is 2-3/4 to 3-1/4 turn out... should I put them back to that OR is there and intial setting I should start with?
after initial I'll need to know the best way to tweek them?
Thanx in advance,
-=Fred=-
93 model j200STLETF SER # g03504324
I am rebuilding my carbs after motor has been sitting. high speed needle is pretty gummed up... so I'm doing a complete tear down and clean.
Here is my question
Boat ran well when I last ran it but the idle was a little rough (a boat shop rebuilt the carbs last)
Anyway each carb (6 of them) is 2-3/4 to 3-1/4 turn out... should I put them back to that OR is there and intial setting I should start with?
after initial I'll need to know the best way to tweek them?
Thanx in advance,
-=Fred=-
