91 Evinrude 70hp really bad cold start

dwyllie1215

Recruit
Thread starter
Joined
Mar 8, 2017
Messages
3
This motor is on my pontoon boat and it is tough to start. im talking 30 minutes of trying and then finally it will start. Once it starts, it will start up first time, every time. but if it sits for a couple days, its back to being cold start problems. I've always worked on my own cars but i don't know much about boats. I'd like to be able to fix this myself instead of paying big bucks at the shop. FYI last fall i rebuilt all three carbs and it still acts up. Last couple times i had it out last year, i would accelerate and get about halfway on the throttle and it acted like it hit a wall with the power, didn't want to go faster than that. not sure what that is about either.
 

David Young

Chief Petty Officer
Joined
Jul 12, 2015
Messages
485
I use to flood my 1977 70 hp Evinrude and it was because of "operator error". Once I learned how to start it the way "it likes'. It starts on 2nd to 3rd, 7 second cranking for the first starting of the day. After it has ran for a few minutes it will start on the first cranking for the rest of the day :)
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Is the electric primer working ?------Do you push the key in and hold it in while cranking ?
 

dwyllie1215

Recruit
Thread starter
Joined
Mar 8, 2017
Messages
3
I do push the key in when i try to start it. i'm not sure about electric primer.
 

dwyllie1215

Recruit
Thread starter
Joined
Mar 8, 2017
Messages
3
silver tip i wasn't aware of a cold start procedure. But what i usually do is check to see if the bulb is primed and i'll just try and start it. i'll push in the key and try and start. i may have to do like david and try to find out how it likes to be started. because i smell fuel and i believe i'm flooding it also when i'm trying to start it.
 

Will Bark

Lieutenant
Joined
Aug 1, 2010
Messages
1,470
Get battery load tested, if motor is not spinning 250/300 RPMS it probably isn't going to start easily if at all. Good luck
 

flyingscott

Fleet Admiral
Joined
Apr 8, 2014
Messages
8,348
Are you using the high idle lever when you start the motor? Is the motor new to you? Is this a problem that just showed up? To check the primer for function have somebody push the key in while you listen for the click. Another check is to turn the red lever on the primer to 90 deg and pump the ball a couple of times. Then turn the red lever back to where it was, inline with the primer body and see if the motor starts better.
 

jakedaawg

Rear Admiral
Joined
Jun 26, 2012
Messages
4,275
There is a good cold start procedure in the stickies at the top of page.

Do you have a side.mount remote control, a flush mount remote, or a binnacle? The fast idle advance is a little different on each control but we have had a few post on here that did not know about it....
 

Roberthill

Petty Officer 1st Class
Joined
Dec 3, 2012
Messages
317
Smelling fuel !!! Check your primer hoses ,might be split or off ,take cowling off and pump fuel bulb hard push key in see if any fuel leaking somewhere . I had this problem recently .
 
Top