91 150 HP Intruder Spitfire series alarm sounding

[Sparky12]

When I turn the key on and start the motor, I get a steady alarm from the console. It's pumping water and there is water pressure showing on the gauge. The oil reservoir is full. The engine operates fine. If I turn the key on and not start the engine the alarm continues to sound. Is there a way to trouble shoot this with the boat on the trailer in the garage? Any ideas?

 

[racerone]

Perhaps faulty electronic in the buzzer itself.-------------Look into replacing the buzzer.

 

[boobie]

Check the temp sensors on the motor by disconnecting them and see what happens.

 

[Sparky12]

Ok. I will. I checked again and I get a 1/2 second pulsing alarm when I turn the ignition on without starting the motor. It stays on as long as the key is on. I'm getting 7 VDC to the buzzer. I'm assuming the tone of the buzzer changes with different voltages from the sensors based on the continuity of the sensors? Thanks for the help!

 

[boobie]

Did you have the temp sensors in the cyl heads disconnected when you did this ??

 

[Sparky12]

I think I found it. The low oil in reservoir does not have continuity. I'll try it out later to make sure it's ready for a spoonbill snagging trip tomorrow. Thanks for the help.