8spl float drop spec

northernfj

Recruit
Thread starter
Joined
Mar 17, 2018
Messages
4
Cylinders on one side of engine were running hot so decided to rebuild carbs. When putting them back together I can find online that I should make float level with carb body but can't find what the float drop spec should be. I measured the original drop specs and one was at 1 inch and the other at 1 & 3/16 inch. The carb has 1 & 3/16 stamped into the face. Any help would be appreciated.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Find out why one side is running hot-----Look into issues with water diverters in the block.-----Cylinder head is taken off to find them-----Look into thermostat / poppit isues too.
 

northernfj

Recruit
Thread starter
Joined
Mar 17, 2018
Messages
4
Replaced the thermostats. Had a conversation with a marine mechanic and he suggested carb issue, but was too busy to assist. Took carbs off and the the jets in the bowl of the lower carb were gummed up. All clean now and want to put it back together and test to see if that solved the issue but need to know the float drop spec. I assume it was running lean before.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
In many years I have not been too concerned about " float drop " and will not be concerned in the future either.
 
Top