82 mariner 9.9 built by yamaha, need parts help.

Cap'nAARGH

Recruit
Joined
Feb 26, 2011
Messages
4
Hello all, this is a great site!

I am in need of some information on a 82 mariner 9.9, I know this motor was made by yamaha for mariner, I have searched for the information I need but am unable to find it. Any help will be very much appreciated!

Mariner 9.9M
Serial# 682 CS 030677
I'm in need of lower unit seals, impeller kit, manual...
If someone can help me with a link specific to this motors parts or a parts # crossover I would be very grateful. This outboard seems to be extremely hard to find information for.
Cap'nAARGH
 

roscoe

Supreme Mariner
Joined
Oct 30, 2002
Messages
21,861
Re: 82 mariner 9.9 built by yamaha, need parts help.

Welcome to iboats.

MERCURY PART NUMBER FOR THE IMPELLER 47-84027T

For the entire water pump kit 46-84277T

Manual ?? repair manual? go generic, like a Clymer Mariner manual that covers the model and year.

Owners manual? good luck , But you can find all you need in the repair manual.

I can't find anything for the lower unit seals.
Your best bet is to contact a Mercury dealer.
 

Cap'nAARGH

Recruit
Joined
Feb 26, 2011
Messages
4
Re: 82 mariner 9.9 built by yamaha, need parts help.

YES! That is what I was looking for Roscoe, THANK YOU!!! That should help greatly. Manual I am interrested in is the shop/repair manual... Found a generic that should at least help... I'm new to outboards obviously...
This is a wonderful site full of helpful people.
 

Cap'nAARGH

Recruit
Joined
Feb 26, 2011
Messages
4
Re: 82 mariner 9.9 built by yamaha, need parts help.

And thank you too Gerry!!! I was confused on what exactly I was supposed to be looking for.
You guys are awesome!!!
 

Cap'nAARGH

Recruit
Joined
Feb 26, 2011
Messages
4
Re: 82 mariner 9.9 built by yamaha, need parts help.

I did call a merc dealer, a few of em but they all told me that the motor isn't a mariner, didn't match up with anything... I saw a thread about a similar motor, (15hp) same year I believe, and in the thread was advised that yamaha parts from the 6E3 (I think) would work but I don't know if that would be the same for the 9.9 I have. I heard the only difference between the 9.9 and the 15 was the carb but once again I don't know for sure and hate ordering the wrong parts...
I am also needing to know where exactly the outflow is, no "pee hole" on this one. So I'm guessing it outflows from the prop area?
 
Top