79 Johnson 115 spark stumper

Bucksmoveme

Recruit
Thread starter
Joined
Mar 11, 2016
Messages
1
I have a 79 Johnson 115 that's giving me fits. It started a couple weeks ago I was out on the lake and my boat would not get on plain. It just didn't have enough power. I narrowed it down to a power pack and replaced it. It ran fine for the next couple days. I decided that with the motor being 35 years old it might not be a bad idea to replace all four coils and the other power pack so I ordered them and installed them. The boat ran great the next time I took it out. The second time I took it to the lake however it had low power again. I determined the #1 plug (upper starboard) was not firing. I switched the coils with #1 and #3 (lower starboard). Now no fire either place. I then switched coil #2(upper port) with coil#3. I had good spark on 3 and no spark on 2. Next switched #4 with #2 had spark on 2 and no spark on 4. Switched 2 with 1 no spark either place. Seems to me every coil I install on #1 is blown and will not work in any spot afterwards. Is this a power pack fault burning up only coils in #1 cylinder or is there another place I should be looking?
 

emdsapmgr

Supreme Mariner
Joined
Dec 9, 2005
Messages
11,551
You may have an issue with the stator. If it's voltage output falls below the minimum required output, it can cause firing problems. Low voltage output won't be enough to fire every coil on every rotation of the crank. It may appear to be a random failure, such as you describe. Check out the ignition troubleshooting guide found at this website: cdielectronics.com. While you are checking it for cranking voltage output, you might as well also check the timer base cranking output. This website lists condemning voltages for both components.
 
Top