'67 Evinrude 5HP Angler-Water on #1 spark plug?

TroutbumShawn

Cadet
Thread starter
Joined
May 28, 2016
Messages
16
Hi, have a 67 Angler that will start, run for a couple minutes then slowly taper off and die, then won't start again till she sits for a couple hours. I've replaced coils, points, condenser, cleaned carb and changed the low speed jet with no change. Last time I ran it, I pulled the spark plugs and saw what looked like water droplets on the plug. What would cause that, a crankcase seal?
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
Most likely a head gasket. Less likely an exhaust cover gasket. A defective carbon seal on the drive shaft will admit water to the powerhead, but not that much.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
The replacement head gasket is better quality than the original.------Good deal on the Sierra product.
 
Last edited:

TroutbumShawn

Cadet
Thread starter
Joined
May 28, 2016
Messages
16
Nope, its not overheating but when I finally gave up and dropped the lower leg to swap it to my spare I noticed the carbon seal that is supposed to be between the spring and crank seal on the drive shaft was completely gone along with the o ring that sits inside it. I'm guessing that was a huge portion of my problem, however I went ahead and got enough pieces together to put the lower leg on my spare motor, and with a fuel pump swap, that one is alive and running for my Father's Day outing at least.
Warning to anyone attempting the lower leg removal to rebuild the impeller or whatever: make sure you have all pieces and when reassembling, be VERY careful that everything goes in as advertised. The crank seal has a nasty habit of sliding to the side.... Best to keep the motor straight up as possible.
 
Top