54 sea horse question

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
No Title

This may be unrelated to the immediate problem, but have you checked out the rest of that motor? Specifically, have you checked the ignition system? There is no such thing as a 1954 Johnson with good coils--unless they have already been replaced. You will never get it to run right if they are old, cracked coils. You can remove the recoil starter and cover plate from the flywheel and peek in to see.
 

Attachments

  • photo237493.jpg
    photo237493.jpg
    67.8 KB · Views: 0

Bearhunter08

Cadet
Thread starter
Joined
Feb 6, 2016
Messages
11
No I haven't checked the coils on it. That will be something I look at the coming up weekend. Thanks for the info.
 

Bearhunter08

Cadet
Thread starter
Joined
Feb 6, 2016
Messages
11
You also would need to remove the actual check valves as well. Then plug one of the channels. That way, you are getting pulse to run the pump. Trim the vacuum plug so that the intake manifold holds it in place. If one of the holes is not properly sealed, the vacuum and pressure pulses will cancel each other out. If you do not remove the check valves, you will only get a pressure pulse, not a vacuum pulse.

I prefer to plug the old pressure line completely, then add a barb to the bypass cover for the pulse to run the pump. I understand though that the bypass covers are not removable on the 5.5hp, that is why a lot of guys resort to modifying the intake manifold on them.

Following article may help

http://www.outboard-boat-motor-repair.com/Johnson/Pressureized Fuel Tanks.htm

That little connector in the page you linked is what I am missing. My motor didn't come with one when I bought it.
 
Top