abdyer2001
Recruit
- Joined
- May 29, 2012
- Messages
- 5
I have a 50 hp evinrude,(ec50tlccs) took it out for first time. It started fine at first, after a few minutes iwould not idle. the motor will idle when i increase the speed using the speed arm on the control lever. as soon as i reduce it to normal idle, it shuts down. when I use the speed control, the engine will sound a little sluggish till it revs up.
I put engine in gear (foward) moves along fine, a little higher than idle. when i give it more throttle, engine does not seem to have full power.
the primmer bulb does not remain firm.
(I have cleaned the carbs, and changed fuel filter,cleaned plugs)
engine will run when out of water, sounds fine, but still same idl problem.
(contacted the previous owner he had replaced th carbs on this motor, with the carbs from a 40hp. could someone correct me if i am wrong. but the 40hp carbs on a 50hp motor would cause my powerproblem?)
I put engine in gear (foward) moves along fine, a little higher than idle. when i give it more throttle, engine does not seem to have full power.
the primmer bulb does not remain firm.
(I have cleaned the carbs, and changed fuel filter,cleaned plugs)
engine will run when out of water, sounds fine, but still same idl problem.
(contacted the previous owner he had replaced th carbs on this motor, with the carbs from a 40hp. could someone correct me if i am wrong. but the 40hp carbs on a 50hp motor would cause my powerproblem?)