boltonranger
Petty Officer 1st Class
- Joined
- May 2, 2004
- Messages
- 204
I have an '88 470 that I just am finishing replacing the cam seals on.
A little tough only because of the unknowns, interruptions etc.
But I have a question about wiring the stator to the regulator [ It's all oem.].
I labeled the wires before I pulled them off; [yellow with red stripe]
but as I am putting them back it's labeled different than I remember [brain freeze] IOW I marked the "front" wire as going to the front lead on the regulator. The problem; I could have sworn I marked the rear wire.
Is there a way to tell if I did it right?
How would I check?
-br
A little tough only because of the unknowns, interruptions etc.
But I have a question about wiring the stator to the regulator [ It's all oem.].
I labeled the wires before I pulled them off; [yellow with red stripe]
but as I am putting them back it's labeled different than I remember [brain freeze] IOW I marked the "front" wire as going to the front lead on the regulator. The problem; I could have sworn I marked the rear wire.
Is there a way to tell if I did it right?
How would I check?
-br