30hp Johnson running without PowerPack

SVB1965

Cadet
Thread starter
Joined
Oct 18, 2016
Messages
7
I recently bought a 1990 or so 30hp Johnson for $100 on craigslist. The id plate is missing so I cannot get the model or serial number to identify the exact year. The compression measured 125 psi in each cylinder. It has electric start but it was very difficult to start. I did get it running a handful of times for about a minute each time. I began to troubleshoot the carb but then noticed there was no power pack on the motor. The mounting holes are on the block but no power pack present. The wires leads that would have gone to the power pack were connected to other wire leads. My question is "How does the motor run at all without a power pack?"

thanks for your help...
 

jakedaawg

Rear Admiral
Joined
Jun 26, 2012
Messages
4,275
No Title

It may have a round disc similar to the one in this pic on top of the cylinder. Those would be the numbers needed to determine what you have.
 

Attachments

  • photo251695.jpg
    photo251695.jpg
    107.6 KB · Views: 1

flyingscott

Fleet Admiral
Joined
Apr 8, 2014
Messages
8,348
You have the UFI ignition everything is under the flywheel. Check for spark with an open air tester first if that tests good leave it alone until it goes bad and those do go bad. To be sure follow the orange coil wires if they go under the flywheel that is where the module is. They had problems with wires being pinched on those especially if you have the original module.
 

SVB1965

Cadet
Thread starter
Joined
Oct 18, 2016
Messages
7
Thanks for the info. I had an '86 30hp Evinrude and it had a Power Pack mounted on the block. This Johnson has the same mounting holes. I am posting pics below - does anyone have an idea of the year? I think it is a late 80's or early 90's. When was the UFI ignition system used by OMC? There is no rating plate and I did not see the disc one of the members referenced. I appreciate everyones' responses.

Motor rear view.jpg Motor_front_view.jpg Motor_Rear_Exterior.jpg Motor flywheel.jpg
 

jakedaawg

Rear Admiral
Joined
Jun 26, 2012
Messages
4,275
You would pribably get best results with a new what year is my motor type thread. Explain its UFI and no welch plug/disc. There are a few guys on here that are really good at that.
 

jakedaawg

Rear Admiral
Joined
Jun 26, 2012
Messages
4,275
You have the oldnstyle primer with out the schrader valve, that means something but I cant remember the year they switched.
 

jakedaawg

Rear Admiral
Joined
Jun 26, 2012
Messages
4,275
My best guess is 89 or 90 j30el...

I think 91 they put the schrader valve in.

Two different fuel pumps though. Post a pic of fuel pump and that could help someone narrow it down.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Under the flywheel module was used from 89 to 93.--------But your cowling indicates an 89 / 90 model.
 
Top