3.8liter OMC trim motor bleed

[powderhombre]

I removed the electric motor hydrolic pump that runs the power trim, and sent it off to have new brushes installed. Now I have to re-install and bleed the system of air. Can anyone walk me through the process of bleeding the system? It looks as though it may be a pain to keep the reservior topped off while doing this as the fill holes are located on the back side of the pump. any suggestions?

 

[Gary H NC]

Re: 3.8liter OMC trim motor bleed

It should be a self bleeding system,fill with fluid...run it up and down several times and top off the fluid..It may take a couple times to get all the air out.