[FONT=Courier New, monospace]I recently bought a pontoon boat with this 2002 75hp two stroke(1075412ZN ELPTO) . It ran good above idle, but stalled out frequently at idle. [/FONT]
[FONT=Courier New, monospace]Since it looked pretty dirty, I decided to remove and clean the carbs. After re-installing, the engine does not start. It cranks, pops occasionally and even might run on a cylinder for a second or two. Choking via key (I know, it actually just enriches mixture) seems to make it worse. I initially set idle needle at 1 ? turns. I do notice fuel/oil mixture on the ground (under prop) after some cranking. [/FONT]
[FONT=Courier New, monospace]How do I troubleshoot this? Did I maybe not get inlet needle valve and float attached correctly? I guess I have to pull it back apart, but looking for other ideas. [/FONT]
[FONT=Courier New, monospace]Since it looked pretty dirty, I decided to remove and clean the carbs. After re-installing, the engine does not start. It cranks, pops occasionally and even might run on a cylinder for a second or two. Choking via key (I know, it actually just enriches mixture) seems to make it worse. I initially set idle needle at 1 ? turns. I do notice fuel/oil mixture on the ground (under prop) after some cranking. [/FONT]
[FONT=Courier New, monospace]How do I troubleshoot this? Did I maybe not get inlet needle valve and float attached correctly? I guess I have to pull it back apart, but looking for other ideas. [/FONT]