optitackle
Cadet
- Joined
- May 5, 2019
- Messages
- 6
Out a couple weeks ago and hit bottom. Took part of the lower unit off.
Replaced the lower unit and everything was going good during break in until i hit the 3200 rpm range of break in when the overheat alarm goes off.
Dropped the lower unit to make sure everything was together correctly. Impeller in correct. Everything hooked up properly.
Changed the t-stats and pressure relief valve.
Back out again and alarm goes off at 3200rpm.
Waterflow is great out of telltale.
Checked the temperature of the heads with a temp gun and get a reading of 162.
Confused as to what might be going on.
Boat has always been well maintained and only ever run in freshwater.
Does anyone have any ideas as where i should go next?
Thanks.
Replaced the lower unit and everything was going good during break in until i hit the 3200 rpm range of break in when the overheat alarm goes off.
Dropped the lower unit to make sure everything was together correctly. Impeller in correct. Everything hooked up properly.
Changed the t-stats and pressure relief valve.
Back out again and alarm goes off at 3200rpm.
Waterflow is great out of telltale.
Checked the temperature of the heads with a temp gun and get a reading of 162.
Confused as to what might be going on.
Boat has always been well maintained and only ever run in freshwater.
Does anyone have any ideas as where i should go next?
Thanks.