1993 115 hp evinrude fuel line connection????

[Lat48]

I'm trying to figure out the routing of the fuel lines. I've got most of them, but there is a small hose on the linkage side stcking out of the side of the crankcase. It's short, about 5 inches long. I haven't put the carbs back on yet Any ideas??

 

[Daviet]

Re: 1993 115 hp evinrude fuel line connection????

Is #35 what you are talking about?
http://www.ishopmarine.com/ishop/js...nown&isFrPG=false&forItemCode=&pCode=C0192058

 

[Lat48]

Re: 1993 115 hp evinrude fuel line connection????

That looks like it. Mine is a TE115LETS. Does it go to the 2 lines t ed together that are between the carbs?

 

[Lat48]

Re: 1993 115 hp evinrude fuel line connection????

I looked at the routing diagram in another post, but it was not the same on all lines. I was able to get most but the small ones are routed way different. I had the block bored and re sleeved, took so long to get back to this point, I forgot.

 

[emdsapmgr]

Re: 1993 115 hp evinrude fuel line connection????

There is an airbox drain hose, but that is on the lower front of the intake manifold-not the linkage side. You may need to post a picture..

 

[Lat48]

Re: 1993 115 hp evinrude fuel line connection????

Hope these help. Many thanks.

 

[Lat48]

Re: 1993 115 hp evinrude fuel line connection????

Does the hose I'm pointing to attach to the tee'd hoses that are between ther carbs?

 

[emdsapmgr]

Re: 1993 115 hp evinrude fuel line connection????

Factory service manual pictures # 17273 and 17339 both show that hose as your pictures indicate. Appears that the hose is much longer and runs straight downward from that hose barb towards the lower cowling. Unfortunately, it does not show where the other end connects. I know that's not much help.

 

[Sureshot]

Re: 1993 115 hp evinrude fuel line connection????

To me, that hose looks like the small hose that runs from the primer solenoid to the carb.

 

[Lat48]

Re: 1993 115 hp evinrude fuel line connection????

The only thing I see that it is long enough to reach is the tee of the 2 hoses between the carbs. I have had a ***** of a time with this motor, being my first multi cylinder repair. However, in my search to find one to look at, I came up with a 470 merc cruiser boat with 2 extra parts engines and will make the extra parts available once I get finished with this one and can give the merc a good once over.
Thanks for the help. I'm sure I'll need more before this is over. LT