shipwreck
Petty Officer 1st Class
- Joined
- Nov 23, 2006
- Messages
- 263
1989 yahama -no fuel at carb for wr500f waverunner
Compress is 125 on both cyclinders.
This mikuni carb that is used a shop put this carb. on last winter, i have clear fuel lines so i could see no at carb. .
I checked and clean all lines - can be blown threw by mouth clear to carb, check fuel filter in tank -all good .
So I took off carb clean and reassembled. Then tested, still nothing-so i hook tank directly to carb. @ fuel pump would start- note it start and runs when i put fuel/oil mix down carb -then stops run when fuel/oil mix runs out.
Now i have taken the carb total apart. There is gas in the chamber with the needle( now) before none- still will not start/run .So- cleaned ,compress threw passage,took needles out- reassembly.
Question, i have pictures... can u tell me if the line are right to carb.?
Since i did hook them up a small shop did it ?-see pictures.
On boat carb you can blew threw upside down -air threw /right no air-
*****I know this not the same***
but is there a way to test this carb by blew threw them?
Where can i get a rebuild kit for this type carb, there is no model on it?
Compress is 125 on both cyclinders.
This mikuni carb that is used a shop put this carb. on last winter, i have clear fuel lines so i could see no at carb. .
I checked and clean all lines - can be blown threw by mouth clear to carb, check fuel filter in tank -all good .
So I took off carb clean and reassembled. Then tested, still nothing-so i hook tank directly to carb. @ fuel pump would start- note it start and runs when i put fuel/oil mix down carb -then stops run when fuel/oil mix runs out.
Now i have taken the carb total apart. There is gas in the chamber with the needle( now) before none- still will not start/run .So- cleaned ,compress threw passage,took needles out- reassembly.
Question, i have pictures... can u tell me if the line are right to carb.?
Since i did hook them up a small shop did it ?-see pictures.
On boat carb you can blew threw upside down -air threw /right no air-
*****I know this not the same***
but is there a way to test this carb by blew threw them?
Where can i get a rebuild kit for this type carb, there is no model on it?
