1989 Johnson 70 hp not firing

Mcdave

Recruit
Thread starter
Joined
Aug 29, 2017
Messages
2
Recently when I have gone to start my 70hp it would sometimes start and sometimes not. I thought it was maybe flooded. I would come back later and fire right up. It now is not firing at all on any cylinder. I was told to unhook the kill switch wire on the motor and see if that worked. Can anyone tell me which wire or wires that is? Any other ideas would be greatly appreciated.
 

tlewis1

Petty Officer 2nd Class
Joined
Oct 9, 2012
Messages
112
When you say not firing you mean there is no spark to any of the plugs? How have you confirmed this do you have a spark tester set to the proper gap? No spark on any cylinder would typically indicate a bad power pack or trigger. Spark to only one or two cylinders could be a bad coil. These guys have a good trouble shooting procedure http://www.cdielectronics.com/. Find your engine in there work book and have a read through it.
 

mrcj001

Petty Officer 1st Class
Joined
Jul 25, 2008
Messages
313
A bad kill switch usually WONT shut off the engine.....If it looks to be like the original power pack its probably bad.....after almost 30 years in service. Mine lasted about 32 years
 

tlewis1

Petty Officer 2nd Class
Joined
Oct 9, 2012
Messages
112
Likely a bad power pack. To confirm use the guide I posted above so your wasting money on parts that may not be required.
 

175se

Petty Officer 1st Class
Joined
Mar 6, 2014
Messages
274
The wire your talking about is a black/yellow (black wire with yellow tracer).
 
Top