2hp newbie
Cadet
Thread starter- Joined
- Aug 24, 2017
- Messages
- 6
Greetings all! I am new to the forum. Great site here!
I am a first time owner of a outboard motor so please forgive my limited knowledge.... I recently i bought a 1985 2 hp Johnson Seahorse outboard for my aluminum boat. I've used it a few times this summer, runs fine... until about a week ago. I was trying to start the motor on a cold start after about a week of non use. ( FYI my boat is at a small marina so motor is exposed to elements) ....tried starting it a few times, then suddenly the entire chord length came out as I tried pulling the start chord once more.
[FONT=verdana, geneva, lucida, lucida grande, arial, helvetica, sans-serif]Now I cannot get it back in to recoil. I've seen you can get to the recoil system ( SORRY ,not sure what you call it ) as its on the top of the cover , underneath, however when I went to unscrew the top screw on top of the cover, it won't budge! is this how I gain access to the recoil? How do I wind the chord back up? or is there a correct/other way? Any info would be greatly appreciated! Very Best![/FONT]
Don G.
I am a first time owner of a outboard motor so please forgive my limited knowledge.... I recently i bought a 1985 2 hp Johnson Seahorse outboard for my aluminum boat. I've used it a few times this summer, runs fine... until about a week ago. I was trying to start the motor on a cold start after about a week of non use. ( FYI my boat is at a small marina so motor is exposed to elements) ....tried starting it a few times, then suddenly the entire chord length came out as I tried pulling the start chord once more.
[FONT=verdana, geneva, lucida, lucida grande, arial, helvetica, sans-serif]Now I cannot get it back in to recoil. I've seen you can get to the recoil system ( SORRY ,not sure what you call it ) as its on the top of the cover , underneath, however when I went to unscrew the top screw on top of the cover, it won't budge! is this how I gain access to the recoil? How do I wind the chord back up? or is there a correct/other way? Any info would be greatly appreciated! Very Best![/FONT]
Don G.