1983 140 hp johnson outboard replacing head gaskets

GBrown7560

Cadet
Thread starter
Joined
Mar 1, 2016
Messages
6
pulled off head and cover plate found grey thick stuff on head side of cover gasket and on cover side of cover gasket ,should all grooves on both sides of cover be filled with anything or do i need clean out all grooves .if need to be cleaned what type of gasket sealer do i need .and can i use same seal on head gasket
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Need to clean the corrosion out of the heads.-----Need to replace those 4 rubber water guides found in the block.----The heads are warped, yes they are !-----Need to refinish them so they are flat.-----New factory head gaskets are marked for correct installation.----Marked with " do not use sealer " as well.
 
Top