crestcraftfishman
Cadet
- Joined
- Jul 16, 2011
- Messages
- 19
Hi everyone. I bought a boat from CBGale2 and splashed it yesterday. It is a 79' starcraft holiday that is a restore project. The engine fired with little issue. Once warm Starts very fast and runs good. Though at idle it has a bit of a miss? I figure a can of seafoam might be in order and run it again. The engine has sat for a while. I did all of the pre start inspection lube etc. is there anything I need to know about this year of Johnson outboards? I also plan on installing a temp sensor with gauge or buzzer. Is this a must have with these outboards?
My other project is installing the TNT wiring. TNT is on the motor and works. I just need to wire the remote switch and the control handle switch. Here is what I have to work with.
And the other 2 pieces of harness
I found a wiring diagram that I think I may understand. But I see more wires than the diagram shows. Maybe the extra wires are for TNT gauge? idk. Anyone have some ideas? Thanks
My other project is installing the TNT wiring. TNT is on the motor and works. I just need to wire the remote switch and the control handle switch. Here is what I have to work with.
And the other 2 pieces of harness
I found a wiring diagram that I think I may understand. But I see more wires than the diagram shows. Maybe the extra wires are for TNT gauge? idk. Anyone have some ideas? Thanks