1979 70hp shift rod confusion

Ralph Porter

Cadet
Thread starter
Joined
Apr 4, 2017
Messages
7
Hi,

I am in need of some expertise please! When I drop the gear housing from the exhaust housing the shift tube won't pull through the exhaust housing case, the hole is too small to accommodate the kink in the rod or indeed the flattened connector part on the end, it will only accept the rod from above so i have to unscrew it from the gear box and pull it up through exhaust housing.... Now I've read that the length is critical so in doing that i have another problem. Am i missing something here, it doesn't seem right to me but i can see no other way?

Many Thanks,

Ralph.
 

Keyboardman

Petty Officer 1st Class
Joined
Sep 10, 2015
Messages
364
Should have a rubber grommet on the housing right below the bend in the rod that the rod will slip thru. Has the rubber hardened up? Also yes, the length of the shift rod is very important. you should count how many times you unscrew it 360 degrees and re install it back the same amount, if, you have to unscrew it to get the LU off.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
This job has been done thousands of times.------Just give it a good pull it will come down through there.
 

Ralph Porter

Cadet
Thread starter
Joined
Apr 4, 2017
Messages
7
What a Muppet I am! Adopted this engine in pieces, the previous owner has had the exhaust housing resprayed, they hadn't removed the rubber grommet but just sprayed over it, it looked and felt mettalic as if part of the housing so i never realised it was a flexible part! Of course now I have to reposition the rod since in my ignorance I had totally unscrewed it. Doh!

Many Thanks

Ralph.
 
Top