Re: 1976 SeaRay SRV200 HELP....
I found this on ebay will they work on my boat? i hope so because i got them for dirt cheap i was the only one that placed a bid on them
You are bidding on a Mercruiser I/O Lower Unit Parts from a 1980 V8 motor as pictured below. These lower unit parts were functioning fine when removed from motor with a blown motor a few months ago and there were NO water or metal filings in the oil. There are NO pits, chips, or grooving on the gears. Both the Drive & Propeller Shafts are perfectly straight, and the bearing & seal surfaces are smooth. The propeller shaft has NOT been hammered to remove a stuck propeller.
Parts Included:
- FORWARD GEAR, 33 teeth (Good Condition)
- REVERSE GEAR, 33 teeth (Good Condition)
- PINION GEAR, 20 (Good Condition)
- PROPELLER SHAFT, 15 splines (Good Condition)
- DRIVE SHAFT, 13 splines (Good Condition)
- SHIFT SHAFT, 6 splines (Good Condition)
- CLUTCH DOG (Good Condition showing No wear)
- PROP SHAFT BEARING CARRIER (Good Condition)
- SHIFT CAM (Good Condition)
- ALL BEARINGS & SHIMS (Good Condition)
- WATER PUMP HOUSING (Good Condition)
These lower unit parts should fit all 4, 6 & small 8 cylinder Mercruiser-Two's from the 1970's up to 1982 that have the spring loaded tip on the end for the driveshaft. They will NOT fit the newer Alpha-One series outdrives from 1983 up to 1990's & 2000's and the huge TR outdrive series for large V8's from the 1970's or Mercruiser-One's from the 1960's.
These parts will be oiled down and packaged securely for safe shipping.
