1973 115 johnson vernatherm

Dodgeviper80

Recruit
Thread starter
Joined
Jun 9, 2018
Messages
1
Can't seem to figure out the cooling water route in my 115 johnson. Pulled the vernatherm housing, ran for a couple of seconds to check water path and can't figure it out. Does the vernatherm open at 105 degrees and pressurized the housing forcing the spring in and allow recirculation of water? If so running without vernatherm wouldn't allow water circulation correct?
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
Water from the pump circulates through the powerhead, then is presented via the two hoses to the vernatherm. The vernatherm samples the temperature, and if it is too cool, it remains closed. In that case, water pressure pushes the relief valve off the seat and returns to the water pump for recirculation. This continues till the water is warm enough to open the vernatherm. When it does, water is discharged and is replaced by cold lake water from the pump. This is not a one-time operation, but the vernatherm is constantly sampling the water and opening or closing as necessary to maintain desired temperature.

There is a slot in the plastic vernatherm valve to allow a bit of water to discharge even if closed. This is necessary to cool the exhaust.
 
Top