1971 Stringer tilt motor worm gear and shaft.

[Boomyal]

A friend had the shear pin break on the worm gear/tilt motor shaft. It used a single pin. Apparently later drives used two pins. The point is. the pins are no longer carried by local wholesale suppliers of OMC part. The pin is probably a a standard size. It was not a hollow roll pin but a solid one. Where might one look for an equivalent pin?

 

[Howard Sterndrive]

in the wall of fiddly parts bins at Home Depot or similar hardware store.

We have Fastenal setup at work with every roll pin imaginable. I see no reason why a roll pin wouldn't work. don't need solid.

 

[Boomyal]

Ok, Howard. Thanks!