I finally finished restoring my1968 40 HP Big Twin Evin (Model 40853).
Now I put it on a boat.
It is electric start (no generator).
I had similar motors without electric and it was easy.
I am not used to electric start motors yet.
I have original manual with electric diagram (with generator) and I hope I connected all correctly.
I am not getting spark.
Assuming that all electric parts are good and I adjusted points properly, where should I look first?
There are a lot of wires go back and forth to switches and etc....
Can it be some switch is a problem?
Thanks
Now I put it on a boat.
It is electric start (no generator).
I had similar motors without electric and it was easy.
I am not used to electric start motors yet.
I have original manual with electric diagram (with generator) and I hope I connected all correctly.
I am not getting spark.
Assuming that all electric parts are good and I adjusted points properly, where should I look first?
There are a lot of wires go back and forth to switches and etc....
Can it be some switch is a problem?
Thanks